Call Us Today! (775)-359-1223|

Plumbing and Piping Systems

/Plumbing and Piping Systems
Plumbing and Piping Systems 2018-08-13T13:27:45+00:00

Types of residential hot water piping/plumbing systems including green plumbing layouts, looped piping, branched piping and combinations.


Residential Plumbing Systems

Generally there are two basic types of residential plumbing or piping systems layouts found in typical residential piping; series plumbed and branched. There are of course, many variations and  combinations of the two types.

The figure below represents a typical series plumbed system. I have simplified the illustrations showing only the water heater and sink type fixtures, leaving out showers, bath tubs, etc.

A series plumbed system means that the water lines go from one fixture to the next, then from that fixture to the next, etc.Example of green plumbing layout - this is a looped or series plumbed hot water piping system.

Branched plumbing systems are far more common.

The fixtures are shown in the blue prints, but how the piping gets to and from the fixtures is not shown. Normally, it’s left up to the plumber to figure out the best way to plumb the house. Often this results in less than optimum plumbing layouts.

Even with identical floor plans there can be a number of variations in how the piping is laid out from one house to the next with residential plumbing.

Example of a branched plumbing layout for hot water plumbing from the water heater to the fixtures.

The above diagram shows a branched residential piping system. This is not an efficient way to plumb residential systems.

Branched piping system

The above diagram shows another residential plumbing system, a branched system where all of the fixtures at least have some common piping. It’s a better green plumbing layout, but not perfect.

Cold water pipes are not an issue, since there is no need to purge water from the cold side of the plumbing. Hot water pipes are another matter. Since you often need to purge the cooled off hot water out of the pipes before you can get hot water.

Often due to the hot water pipes being in a crawl space, behind walls, and in attics, it is easier to determine what kind of system you have through testing.

This can be done by measuring how long it takes to get hot water at each fixture allowing the hot water to cool between measurements.

Then run the furthest fixture from the heater  until hot water arrives at the fixture, and then immediately test the other fixtures to see if hot water reaches the fixture more quickly than normal.

Green plumbing layouts when used with a hot water demand system create the ultimate in water and energy conserving hot water delivery systems.